Chengdu Ebyte Electronic Technology Co.,Ltd
Copyright ©2012–2019
，
Chengdu Ebyte Electronic Technology Co.,Ltd
3-6
3. Quick start
This quick use requires our test baseboard.
Instruction
Power supply options:
The jumper cap on this circuit is used to select the power supply mode, which is selected according to the user's power
supply mode.
Boot:
Press the S1 self-locking switch, and then LED0 (green) blinks. 2 seconds later, LED0 and LED2 (blue) blink alternately.
At this time, the Bluetooth named E104-BT30 V1.0 can be searched on the phone, and you can connect
AUX_OUT output power:
Connect the 3.5mm headphones here
Power amplifier circuit:
If the user has a 3W speaker, you can directly connect the two terminals of the power amplifier circuit.
Key control circuit:
PLAY: Music play and pause button, it has the following states.
When connect to a mobile phone, short press the PLAY button to play music and pause.
When connect to a mobile phone, long press to disconnect the current connection and enter the discoverable state.
At this time, LED1 (red) will blink once.
When connect to a mobile phone, when there is an incoming call, short press the PLAY button to answer the call.
V-: This button is volume reduction. There are long-press and short-press of the button.Long-press can continuously
decrease the volume. Short-press decreases
