Chengdu Ebyte Electronic Technology Co., Ltd.
Copyright©2012–2021
ChengduEbyteElectronicTechnologyCo,;Ltd
18
100
:
2500ms
101
:
3000ms
110
:
3500ms
111
:
4000ms
interval period, the lower the
average power consumption, but the
greater the data delay
Both the transmitter and the receiver
must be the same (very important).
07H
Write
CRYPT_
H
key high byte
(
Default 0
)
Write only, read and return 0.
Used for user encryption to avoid
intercepting airborne wireless data
by similar modules.
The module will internally use these
two bytes as a calculation factor to
transform and encrypt the
over-the-air wireless signal.
08H
Write
CRYPT_
L
key low byte
(
Default 0
)
80H~
86H
Read
only
PID
7 bytes of product information
product information: 7 bytes
8.3 Factory default parameter
Default parameter
:
62 00 17 03 00 00
Model
NO.
Frequency
Address
Channel
Air data rate
Baud rate
Parity bit
TX
power
E90-DTU
(400SL37
)
433.125MHz
0x0000
0x17
2.4kbps
9600
8N1
37dBm
9. Repeater networking mode
No.
Description
1
After setting the repeater mode by configuration, switch to the normal mode and the repeater starts working.
2
In the repeater mode, ADDH, ADDL are no longer used as the module address, but is correspondingly paired
with the NETID. If the data of one of the networks is received, it is forwarded to another network. The
network ID of the repeater itself is invalid.
3
In repeater mode, the repeater module cannot transmit and receive data, and cannot perform low-power
operation.
Repeater networking rules:
1. Forwarding rules, the repeater can forward data in both directions between two NETIDs.
2. In repeater mode, ADDH\ADDL is no longer used as the module address, and it is used as a NETID forwarding
pairing flag.
Figure:
1
Primary repeater
“Node 1” NETID is 08.
Summary of Contents for 400SL37
Page 1: ...E90 DTU 400SL37 ...