EPX400-xC – Manual
Page 64 / 73
9.
DEVICE PROGRAMMING
Programming of device is possible with “GPRS transmitters configurator”
configuration program described in chapter 7.
. To
program the device establish connection with a device.
Depending on connection mode there are two ways for programming.
9.1.
LOCAL PROGRAMMING
To program a device locally follow the procedure:
a)
Connect PROG joint (on printed circuit) with COM computer port by way of
service wire, defined in option -> RS-232.
b)
Connect power supply to terminals
+12V
and
GND
. After connection and
detection of programming wire a module shall signal this with LED diodes: a
green one shall flash and red one shall flicker.
c)
Launch software and define device options (description is in chapter 3. of this
Manual ). Provide right PIN code for SIM card.
d)
Save settings into memory of device. Saving course is displayed in special
window.
e)
After saving disconnect power supply and disassembly service wire.
f)
Insert SIM card. Connect module wiring pursuant to guidelines from chapter 3.
Turn power supply on.
g)
The device is ready to transmit data.
9.2.
REMOTE PROGRAMMING
Remote programming of device is possible if:
o
user uses GPRS transmitters configurator and GSM modem connected to PC
o
user uses OSM.Server monitoring system receiver
In first case remote programming is possible on CSD channel and its procedure is
analogous to local programming, remembering that “Modem GSM” shall be selected
from connection options (See chapter 7.3.5.2. Remote connection – CSD connection).
Note:
Remote configuration with use of CSD canal is possible only if transmission of
CSD data is active both for SIM card inserted in the device, and for SIM card installed
in GSM modem.
In second case according to description in chapter 7.3.5.2. Remote connection –
GPRS linking, it is required to define remote link on grounds of OSM.Server
parameters. As OSM.Server collects (and transmits) information exclusively from
Summary of Contents for EPX400-5C
Page 20: ...EPX400 xC Manual Page 20 73...
Page 63: ...EPX400 xC Manual Page 63 73...
