EBS EPX400-5C, Installation And Programming Manual

Page: 28 / 73

EPX400-xC – Manual Page 28 / 73
8. PROGRAMMABLE PARAMETERS
Parameters available in configuration program are divided into groups: Access,
Transmission, Inputs/Outputs, Monitoring, Restrictions, SMS Notifications, RS232,
Link control, Phone line and Firmware. Every from these groups will be described in
detail in next part of this manual.
8.1. ACCESS
8.1.1. Transmitter
This tab contains parameters for access to the transmitter and SIM cards.
8.1.1.1. Service Code
It provides security against unauthorized access. It is being used during
programming of device and during remote controlling (in TCP/IP or SMS mode).
Factory setting is 1111 . During the first starting of device (programming) it shall be
changed. Code may consist of up to seven alpha numerical characters.
8.1.1.2. Installer code
Allows restricted access to the parameters of device. When installer code is used
following groups of parameters are unavailable: Access, Transmission, Restrictions,
SMS notifications, RS232, Link control, and Phone line. An unauthorized attempt to
access to this parameters causes error notification.
Default installer code:
2222 .