EBS EBS-6100, User Manual

Page: 61 / 134

EBS
Ink-Jet Systems
®
EBS-6100
Printer User's Manual
Paragraph 4 - Operating the Printer
20070529#20.5
59
Print Height
1 Height
2
SMALL , MIDDLE ,
LARGE
3
LARGE
4 YES
The parameter defines the height of overprints. When the
distance from the print head to an object is constant, labels of
three different heights can be printed. The print height setting
applies to the entire text, no matter how the text has been
created in the word processor and what its contents are.
NOTE:
The print height can be adjusted continuously by changing the distance between the print
head and an object. With this type of adjustment you need to take into account the risk to
get lower quality overprints over greater distances.
Date Offset
1
Offset, Offset2
2 0, 1, 2, 3, ... , 9999
3 1
4 YES
The parameter defines the number of days to be added to the
current date in order to calculate the so-called expiry date.
There are two date offset parameters:
Offset and Offset2 . The
expiry date is set with the
Date+offs.
or
Date+offs.2
, special
registers where the above mentioned parameters are used -
see also section
4.4.1.10 Using Special Registers
.
Counter Increment
1
Counter delta
2 1, 2, 3, ... , 9
3 1
4 YES
The parameter is a number added to an incremental counter or
subtracted from a decremental counter. The incremental or
decremental counters are special registers where the
Counter delta parameter is used - see also section
4.4.1.10 Using Special Registers
.
Row Repetition
1 Row repetit.
2 1, 2, 3, ... , 10
3 1
4 NO
The parameter defines how many times each vertical row
should be printed to get the overprint. It applies to the entire
text file, no matter how the file has been created, what its
contents are and how many times individual subfiles are to be
repeated.
NOTE:
An increase in the number of rows to be printed causes the width of the entire print to
increase. If you wish to maintain the previous width of your print and keep the object’s feed
rate unchanged, then each time you set the parameter
Row repetit. at a higher value you
should increase the print rate, i.e. the setting of the parameter Cnv spd m/min , or increase
the setting of the parameter Resol. dot/cm .
!