EBS-6100
Printer User's Manual
Paragraph 4 - Operating the Printer
EBS
Ink-Jet Systems
®
54
20070529#20.5
Terminal key
Function
¥
To assign the
read only
attribute to every block in the
library. The option is available only when the service
password is enabled. If the password level is too low, you
will be asked for a password when you make an attempt to
change the attribute.
¦
To remove the
read only
attribute from every block in the
library. The option is available only when the service
password is enabled. If the password level is too low, you
will be asked for a password when you make an attempt to
change the attribute.
NOTE:
If no parameter blocks are defined in the library, the command is ignored.
4.4.3. Printing
4.4.3.1. Stopping the Printing
The printing can be terminated in two parallel and independent ways:
•
With
the
STOP PRINTING
command on the terminal.
•
With
the
PRINT ON/OFF
key on the main pad of the external panel (when the key
is pressed, the
STOP PRINTING
) command is executed). The key can be used
no matter where the cursor position is within the control menu (for example, you
can stop the printing while editing a text file).
To stop the printing follow the procedure below.
In the main MENU select the
PRINTING
item and then the
STOP PRINTING
item,
or
Press the
PRINT ON/OFF
key on the external panel.
If the command is selected while the printer is in the
mode, the current print job
finishes and no other label is printed. The execution of the command results in the
application of high voltage. The green
PRINT ON/OFF
lamp on the main pad of the
external panel and the red
HV ON
lamp on the internal panel go out. The printer
switches to the
stop
mode.
If the printing is to be interrupted immediately (the current print job is not to be
completed), use the
QUICK STOP
command.
4.4.3.2. Starting the Printing
The printing can be initiated in two parallel and independent ways:
•
With
the
START PRINT
command selected on the terminal.
•
With
the
PRINT ON/OFF
key on the main pad of the external panel. When the
key is pressed, the
START PRINT
command is executed for the text file that was
printed most recently. The key can be used no matter where the cursor position is
within the control menu (for example, you can start the printing while editing a
subfile).
The printing is started in the following way. In the main MENU select the
PRINTING
item and then the
START PRINT
item.
!
Summary of Contents for EBS-6100
Page 1: ...EBS Ink Jet Systems EBS 6100 USER S MANUAL...
Page 2: ......
