EBS EBS 2600, User Manual

Page: 137 / 184

137 of 184
EN
EBS‑2600 User Man
ual
G2023/04/26_1EN 2023.05.16
2. Set a value of the selected parameter.
3. Press
to acknowledge.
The sound signals are modified.
7.4. CONFIGURING COMMUNICATIONS INTERFACES
The configuring of communications interfaces is not available to operator ‑type users.
Operator ‑type users can only get information about basic parameters such as the printer's IP address.
7.4.1. ETHERNET
The printer can be connected to an Ethernet network or directly to a PC via the connector in
the control unit.
For more details see “2.2. Printer Structure” “2.2.3. External Connections” .
The Ethernet interface can be used, e.g . for controlling the printer remotely or for receiving data
from an external device; this data may then be entered to a project via a Communications port ‑type
text object or bar/matrix code .
For more details on how to create/edit a Communications port ‑type text object see “5.4.2.5.
Creating/Editing a Communications port-type Text Object” .
Bar/matrix codes with dynamic contents can be graphic interpretation of a Communications
port ‑type text object and as such they can be created by means of the EBS Web User Interface
only.
To configure the Ethernet interface:
1. Press .
The following parameters need setting to configure the Ethernet interface:
Parameter Range of values
|Basic| Enable networking
/
Activate / deactivate the Ethernet interface.
|Basic| Configure network automatically
(with DHCP)
/
Ethernet configuration mode:
- : network connection parameters are set automatically while a network connection is
being established,
- : network connection parameters are set manually with the parameters IP , Netmask ,
Gateway , DNS available in sheet tab |Advanced| .
For the information on how to set up your network connection manually contact your
network administrator.
|Basic| Current IP information parameter
The IP address of the printer.