EBS EBS 2600, User Manual

Page: 132 / 184

132 of 184
EN
EBS‑2600 User Man
ual
G2023/04/26_1EN 2023.05.16
7. PRINTER CONFIGURATION
7.1. GENERAL SETTINGS
General settings are not available to operator ‑type users.
To modify general settings:
1. Press
| |.
The general settings involve the following parameters:
Parameter Range of settings
Conveyor speed 1 to 200 [m/min]
The parameter is used for defining printing speed only if | | Impulse generator
source = Internal generator for the project being printed.
Set printing speed.
The speed set‑point must equal the real conveyor belt travel speed, which can be measured with
the tool available after the
icon has been pressed.
For more information see “6.5. Determining Factory Conveyor Parameters” and “7.1.1.
Maximum Printing Speed” .
Encoder constant 5000 to 500000 [pulses/m]
The parameter is used for defining printing speed only if | | Impulse generator
source = External source for the project being printed.
The encoder constant, i.e . the number of pulses generated by the encoder per unit length (1 me -
ter).
The encoder constant depends on:
- Number of pulses per one revolution of the encoder in use,
- Circumference of the roll.
To ensure, therefore, that the encoder constant is within the required range, you need to apply
an appropriate encoder and/or a roll with an appropriate circumference.
For example, if the encoder is programmed to generate 63779 pulses/revolution and provided
with a roll 250 mm in circumference, the encoder constant is 255116 pulses/m.
The constant of an encoder connected to the input can be measured with the tool available
after pressing the icon displayed next to the parameter.
For more information see “6.5. Determining Factory Conveyor Parameters” .
Statistics
/
Decide whether the scope of statistics available in the EBS Web User Interface editor shall in-
clude the number of printouts of every project ( ) or not ( ).