38
Note:
The above procedure should be performed with the utmost care because its
improper performance may prevent proper operation of the device.
7.2.4.
Programming adapter and cable
In order to gain access to device's programming functions via RS232 port special
programming adapter (AGP3) and cable (LX-PROG or LX-DATA) is necessary. Adapter
is equipped with two connectors: PROG and MODEM. The first one is used for local
programming, controlling device's state (Device Monitor) and reading device's event
history. The second connector may be used for GSM modem work auditing.
Below is a summary of AGP3 adapter and cables application:
AGP3
LX-PROG
LX-DATA
Device programming
●
●
○
Firmware update
●
●
○
Events history
●
●
○
Device Monitor
●
○
●
7.2.4.1.
Local programming
To program a device locally follow the procedure:
a)
Turn the device upside down, open lid by unscrewing bolts and take it off.
Remove battery from cavity (don't disconnect it!) and fasten AGP3 adapter in a
socket located near SIM card holder
b)
Connect PROG joint (on AGP3 adapter) with COM computer port by way of service
wire, defined in option Connections -> RS232.
c)
After connection and detection of programming wire a module shall signal this
with LED diodes: an orange one shall flash and red one shall flicker.
Note! When Active Track Basic+ is in ultra power saving mode (the
option of Handle SMS commands is disabled), then after inserting the
programming cable, you must press any button on the device.
d)
Launch software and define device options (description is in chapter
Programmable parameters). Provide right PIN code for SIM card.
e)
Save settings into memory of device. Saving course is displayed in special window
