EBS Ink-Jet Systems EBS-6200, User Manual, Page: 65 / 124

EBS-6200
Printer User's Manual
Chapter 4 - Operating the Printer
#1.0
63
20091020
NOTE:
•
The V0 OFF and V0 ON commands are ignored during printing.
•
After the V0 ON command has been executed, the printer remains i
1 minute.
0 ON command must not follow the INK OFF or FAST OFF command because ink
to th
in
n the
restart
mode for
about
•
The V
starts flowing
head and a phas e head through the open V0 valve under pressure and may flood the
g error may occur.
4.4.4.4. Tu ing Hea
In e main M lect the em and then the FAST OFF item.
This command is used for quick-turning off the head without rinsing. It is effective when the ink or
ad is turned on. The command causes ink/solvent to be sucked from the
nozzle and the gun (for about 2 seconds) and the V0 ink valve or the V6 solvent valve are closed. The
executio is
This com plie
•
When the s w
head); the sh ,
•
In order to suppress temporarily (for a few minutes) the flow of ink or solvent to the head (to
perform a service operation, for example).
The be executed safely many times with no risk of thinning the ink.
The gnor
Aft ha
!
rn d off Quickly
SERVICE it th ENU se
solvent flow inside the he
n of the command completed, when the lamp indicators V0 , V1 , V6 go out.
d in the following situations:
orking after the printer has been turned on (before ink is supplied to the
ould be used immediately after the printer has been turned on
mand can be ap
head stop
command
NOTE:
•
•
command can
command is i
ed during printing.
s been executed, the printer switches to the
restart
mode.
•
er the command
4.4.4.5. Turning Ink Flow
U select the SERVICE item and then the INK ON item.
T
command
•
FAST
•
INK O
•
SOLV
red during printing.
After t mand h
2 minutes.
!
on
In the main MEN
he command is used to turn on the head (the flow of ink within the head) after the following
s have already been executed:
OFF ,
FF ,
ENT .
NOTE:
•
The command is igno
•
he com as been executed, the printer switches to the
restart
mode for about
4.4.4.6. Hea
In the main MENU select the
This command is used to tu
giving the
pipes, gun an zles a tho
from the ink system and ele
the
V0 , V1 , V6 lamp indicato
This command can be appli n but you do not want ink to circulate
ithin the head. It is used more intensively for printers with many heads.
!
Turning d off
SERVICE item and then the INK OFF item.
rn the head off completely. The complete turning off consists of
d noz rough rinse (as during the switch off procedure) and of isolating the head
ctronic printing system. The execution of the command is finished when
rs go out.
ed when the unit is to be switched o
w