EBS Ink-Jet Systems EBS-6200, User Manual, Page: 58 / 124

EBS-6200
Printer User's Manual
Chapter 4 - Operating the Printer
56
200
Counter Increment
1 Counter delta
2 1, 2, 3, ... , 9
3 1
The paramete r is a number added to an incremental counter or
used - see also section
4.4.1.10 Using Special Registers
.
subtracted from a decremental counter. The incremental or decremental
counters are special registers where the
Counter delta parameter is
4 YES
Row Repetition
1 Row repetit.
91020#1.0
2 1 ... , 10 , 2, 3,
3 1
4 NO
ould be The parameter defines how many times each vertical row sh
printed to get the overprint. It applies to the entire text file, no matter how
the file has been created, what its contents are and how many times
individual subfiles are to be repeated.
NOTE: An increase in the number of rows to be printed causes the width of the entire print to
in
rint and keep the object’s feed
ra petit. parameter at a higher value you
should increase the print rate, i.e. the setting of the Cnv spd m/min parameter, or
crease. If you wish to maintain the previous width of your p
te unchanged, then each time you set the Row re
increase the setting of the Resol. dot/cm parameter.
Print-Rate Mode
1
Mode
2 NORMAL , FAST
3 NORMAL
4
ed by an internal generator or a shaft-encoder as
high level, the quality of print lowers. The reason for the lower quality is
pulse processing system is turned off, the print control system switches
FAST , the print control system ensures
that the prints are made at the maximum possible rate. Note that the
speed
The print rate is tim
standard. The internal generator (or shaft-encoder) determines the
timing of the printing of vertical rows. When the print rate reaches its
that the print control system needs to react to pulses coming from the
internal generator (shaft-encoder) and to synchronise with them. If the
NO
to timing by itself in the optimal (in this case - the fastest) way.
If the Mode parameter is set to
internal generator or shaft-encoder are turned off, and if the travel
changes, the print width may vary.
on of the shaft-encoder) are not sufficient to obtain proper and visible
ter is set to FAST ), the internal
rate.
NOTE:
•
If the Speed parameter is set to FAST and the adjustment of frequency of the internal
generator (or transmissi
overprints, the printing can still be sped up by setting the print-rate mode to
FAST .
•
When the print rate is set to its maximum (the Mode parame
generator and shaft-encoder have no effect on the print
!
Print Rate
1 Speed
2
SLOW , MIDDLE ,
FAST
3 SLOW
The parameter defines the maximum rate at whic
4 NO
h an overprint is made.
According to the setting of the Speed parameter, different sequences of
. It is recommended that the print rate be as low
as possible (the lower the print rate, the better the print quality).
dots are used for printing