EBS Ink-Jet Systems EBS-6200, User Manual

Page: 54 / 124

EBS-6200
Printer User's Manual
Chapter 4 - Operating the Printer
52
200
cify a text file n p to You are 8- rm, or
alternati s the ¨ key.
prompted to spe ame. Type in an u character name and confi
vely, you can pres
lay shows the text file library from which you should select the name of a text file to be printed
lities are described in section
4.4.1.1 General Info
The disp
(selectio
s ready to print (the mode) and the name of a text file is selected, then high voltage
is applied
lamp on the intern
NOTE:
•
If the START PRINT command is followed by the UNIT NOT ACTIVE message, this means
rocess has not been completed (after the unit has been switched
r the stabilisation of ink parameters (after an error has occurred).
command is followed by the CHANNEL ACTIVE message, this means
DOES NOT EXIST message, this means that no text file with the specified name
•
llowed by a message TEXT TOO HIGH , it means that you
mum height (in pixels) is greater than the height Hmax of
ter is able to print.
•
ollowed by a message PRINT SPEED TOO HIGH , it means
o large or the setting of the distance between prints is too
•
llowed by a message FAST & TEXT TOO HIGH , it means
that you have tried to print a text whose maximum height (in pixels) is greater than 16 for
p
n faci
rmation on Text Files
).
If the printer i
stop
(the green
PRINT ON/OFF
lamp on the main pad of the external panel and the red
HV ON
al panel start glowing) and printing starts. The printer switches to the
print
mode.
91020#1.0
that the initial heating up p
on) or that the unit waits fo
Then wait until the READY lamp stops blinking and repeat the
START PRINT command.
•
If the START PRINT
that the unit is in the
print
mode. Then stop printing (with the STOP PRINTING or
QUICK STOP commands) and repeat the START PRINT command.
•
If the START PRINT command and the selection of a text name are followed by the
TEXT NAME
exists in the text file library.
If the
START PRINT command is fo
have tried to print a text whose maxi
the maximum vertical row that the prin
If the
START PRINT command is f
that the setting of the print rate is to
small for a given print rate.
If the
START PRINT command is fo
S eed = FAST .
4.4.3.3.
If printing
a need may a
Printing can b
then the
QUIC
High voltage i
and the red
H
If printing is finished, use the STOP PRINTING
com
!
Quick Stopping Printing
is stopped in the regular mode, the current print job is always finished to the end. However,
rise to stop printing immediately regardless of the state of the print job.
e interrupted in the following way. In the main MENU select the PRINTING item and
K STOP item.
s disconnected. The green
PRINT ON/OFF
lamp on the main pad of the external panel
V ON
lamp on the internal panel go out. The printer switches to the
stop
mode.
to be stopped but the current print job is to be
mand.