EBS Ink-Jet Systems EBS-6200, User Manual

Page: 114 / 124

EBS-6200
Printer User's Manual
Chapter 7 - Storage and Carriage
112
20091020#1.0
7. Stora
ink to the head and carrying it away from the
head needs to be emptied. When the unit is switched off in the regular mode the ink gets sucked out
illed with solvent. That mode of switching off ensures that
eration after a break which lasts no longer than about one
t clean and washed
cked over
an one week , two problems may
od:
ted,
s with ink drying in the ink system during long-term storage, make sure that
In
3 PRINTE ANDS submenu of the
4 SERVICE menu. A three-item menu appears:
1 UP TO ONE WEEK
The command initiates the regular mode of switching off
(a detailed description is given in
3.2.1 Switching the Printer
Off in Regular Mode
).
ge and Carriage
7.1. Storing the Printer
After the unit has been switched off, the tubes supplying
of the pipes and the pipes are rinsed and f
the unit is fully efficient when it resumes op
week . The inside of the head, especially the nozzle and the gutter are to be kep
with solvent. Additionally, the data stored in the memory of the printer can be battery ba
about 1 month (this refers to parameters, text files, date and time and other data saved and set up by
the user before).
If the unit is to remain idle (in the off state) for a period longer th
arise during that peri
´
the tubing, a valve or any other ink system elements may get dry or blocked, which will hinder the
operation of the device when restar
´
the battery-supplied memory containing user-defined texts and parameters may be cleared
(because the battery may discharge) - after about a month.
In order to avoid problem
the printer is switched off in one of the additional switch-off modes.
order to enable the additional switching-off modes, select the
R STORAGE PREPARATION item from the C SERVICE COMM
2 UP TO 3 MONTHS
A detailed description of the procedure is given further on in
this document.
3 OVER 3 MONTHS
The following message is displayed on the terminal after the
command has been selected:
Empty and rinse ink system
with solvent according to
Service Manual instruction.
.
Follow the instructions from the
Serv e Manua
t
solvent. The procedure can be followed exclusively by
ic l
and at firs
empty the ink system of ink and then rinse the printer with
a serviceperson trained by a printer distributor.
The irs
EB -
off in th nal accessories. In order to follow it, select command
3 P
bein
EBS
f t two procedures referred to in the table above can be used by every user of an
S 6200
printer, however procedure 2 UP TO 3 MONTHS is more complicated than switching
e regular mode and requires additio
2 UP TO 3 MONTHS (menu 4 SERVICE
¹
C SERVICE COMMANDS
¹
RINTER STORAGE PREPARATION ). The procedure consists of a few steps, with each step
g signalled with the appropriate message on the terminal display.