7 Guidelines for station planning
7.7 Firmware download
XI/ON: XNE-GWBR-2ETH-MB
10/2011 MN05002008Z-EN
www.eaton.com
147
7.7
Firmware download
Firmware can be downloaded via the service or an Ethernet interface on the gateway using
the software tool I/O-ASSISTANT. More information is available in the program’s online help.
7.7.1
DIP-switch position
A firmware download to the gateway using the I/O-ASSISTANT, does not require a special
position of the DIP-switches. The described DIP-switch position can be used to "force" the
gateway into the download mode. This can be necessary, if the current supply was interrupted
during the download.
Attention
The station should be disconnected from the field bus when downloading.
Firmware must be downloaded by authorized personnel only.
The field level must be isolated.
Table 75:
Position of the
DIP-switches
for firmware
download
Address switch
Position
2
0
-2
6
0
2
7
1
MODE
1
CFG
1
Figure 72:
Position of the
DIP-switches
for firmware
download
