6 Application example: XNE gateway with an Allen Bradley PLC
6.2 Network configuration
152
XI/ON: XNE-GWBR-2ETH-IP
09/2011 MN05002007Z-EN
www.eaton.com
The following station is used in this application example:
6.2
Network configuration
The XI/ON gateways are delivered with the IP address
192.168.1.1
.
To achieve this, you have either
• to adjust the gateway’s IP address via BootP, DHCP etc. for integrating it into your own
network (for detailed information about the different possibilities for address setting,
please read, Chapter 4.5 Address setting, Page 37).
or
• to change the IP address of the used PC or network interface card (for detailed information,
please read the following Chapter 6.3 Changing the IP address of a PC/ network interface
card, Page 153).
Table 62:
Example station
Module
Data width
Process in Process
out
Alignment
GW
XNE-GWBR-2ETH-IP
0
XN-2AI-I(0/4...20MA)
2 words
-
word by
word
1
XN-2DI-24VDC-P
2 bits
-
bit by bit
2
XN-2DO-24VDC-0.5A-P
-
2 bits
bit by bit
3
XN-2AI-THERMO-PI
2 words
-
word by
word
4
XN-4DI-24VDC-P
4 bits
bit by bit
5
empty slot
6
XN-1AI-U(-10/0...+10VDC)
1 word
-
word by
word
7
XN-2AO-I(0/4...20MA)
2 words
word by
word
8
XN-4DI-24VDC-P
4 bits
bit by bit
9
XN-1SSI
4 words
4 words
word by
word
Note
In order to build up the communication between the XI/ON gateway and a PLC/ PC
or a network interface card, both devices have to be hosts in the same network.
