11 Configuring an EtherCAT system with XSOFT-CODESYS
11.1 General instructions for working with XSOFT-CODESYS-3
66
XN-312-GW-EC gateway
07/20 MN050010-EN Eaton.com
11.1 General instructions for working with XSOFT-CODESYS-3
The following sample table includes columns that are not being shown even
though they exist.
To show the columns, you would need to move the cursor over the column
header border between two columns and then double-click or expand the
next hidden column by dragging the border and dropping it.
Figure 34:
Table in XSOFT-CODESYS-3 with two hidden columns
▶
In the table above, you would move the cursor over the header border
between the "Bit length" and "Next line" columns and click and drag the
border to the right.
▶
You would then move the cursor between "Bit length" and "Jump to line
in case of error" and drag the border between the two to the right.
▶
Finally, you would move the cursor between "Bit length" and "Abort in
case of error" and drag the border between the two to the right.
￫
Please note that the table in XSOFT-CODESYS-3 will often hide
whole columns.
If you are missing any data, make sure that all the columns in
the table are being shown!
￫
Please note that only one hidden column will be shown after
this. If there are multiple hidden columns, you will need to
repeat this step multiple times.
