Transmission appearance may differ, procedure is the same.
49
External Parts
V/08-1
T/60-7
H/46-6
Auxiliary Section
How to Install the Rear Bearing Cover Assembly
Special Instructions
When installing the rear bearing oil seal, press into the
rear bearing cover flush with the machined step. A thin
coat of lubrication may be used on the seal O.D.
Because the collar becomes distorted when
compressed,
do not re-use an old nylon collar
in the
rear bearing cover.
Apply Eaton Lubricant #71214 or equivalent to
speedometer plug O-rings, cover the entire surface. If
the electronic sensor hole has a seal, apply lubricant
#71214 or equivalent, covering the top surface.
Do not
use an O-ring with the seal.
Special Tools
Typical service mechanic tools are needed
Bearing driver and maul
Oil seal installation tool (K-2091)
To Install
1.
If previously removed, install the oil seal in the
rear bearing cover with the proper driver.
2.
The seal should be installed so the spring is to the
transmission front.
3.
Position a new gasket on the rear bearing cover
mounting surface and the rear bearing cover.
4.
Apply Eaton/Fuller Sealant #71205 or equivalent
to the retaining capscrews.
5.
On AT/ATR/ATS models, use a new nylon collar
and brass washer with the capscrew at the
chamfered hole, the hole that intersects the
speedometer bore.
6.
Install the retaining capscrews, tighten to 35-45
Lb
f
·ft of torque.
Final Check
Make sure the capscrews are properly torqued.
1
2
3 4, 6
