Transmission appearance may differ, procedure is the same.
47
External Parts
Auxiliary Section
How to Install the Auxiliary Section
Special Instructions
There are different capscrew lengths, install in the correct
location.
The auxiliary section should be installed with the
transmission in the horizontal position.
Special Tools
Typical service mechanic tools are needed
An auxiliary section hanger bracket for horizontal removal
A steel bar longer than the width of the output yoke for
vertical removal
A hoist with a lifting chain
To install the auxiliary section in the horizontal position.
1.
Position a new gasket on the transmission
mounting surface.
2.
Attach an auxiliary section hanger bracket to the
auxiliary section top.
3.
Attach a lifting chain to the auxiliary section
hanger bracket.
4.
Position the auxiliary section on the two (2) dowel
pins.
5.
Slide the auxiliary section on until the hanger
bracket contacts the front section back.
6.
Remove the auxiliary section hanger bracket.
7.
Install the two (2) allen setscrews. Tighten to 35-
45 Lb
f
·ft of torque.
8.
Apply Eaton/Fuller Sealant #71205 or equivalent
to the retaining capscrews.
9.
Install the retaining capscrews, tighten to 35-45
Lb
f
·ft of torque. On ATE models, tighten the short
(1-1/2") to 26-32 Lb
f
·ft of torque.
10.
Position a new power synchronizer gasket and
power synchronizer on the auxiliary case.
11.
Install the mounting capscrews. Tighten to 35-45
Lb
f
·ft of torque. The middle capscrew uses a
washer.
12.
Move the range cylinder up and forward. Install
the range cylinder housing capscrews, tighten to
35-45 Lb
f
·ft of torque.
H/28-5
H/28-3
H/27-7
8
H/28-7
H/28-4
H/28-2
2
3
1
7
11
