Transmission appearance may differ, procedure is the same.
41
External Parts
Torque Converter
How to Install the Oil Pump
Special Instructions
The oil pump gear can be installed during the torque
converter housing installation.
When installing the oil pump, do not damage the O-
rings and use grease.
Special Tools
Typical service mechanic tools are needed.
To Install
1.
Lube and install the oil pump O-ring in the torque
converter housing oil pump bore.
2.
If previously removed, install a new snap ring.
3.
Lube and install the oil pump O-ring.
4.
Lube the oil pump bore.
5.
Install the oil pump, tap with soft faced hammer if
necessary.
6.
Install the two (2) pump mounting capscrews.
Tighten to 35-45 Lb
f
·ft of torque.
7.
Inside the torque converter housing, install the oil
pump drive gear.
8.
On the oil pump gear, install a new retaining nut.
Use a screwdriver to keep the gear from moving.
Tighten to 34-48 Lb
f
·ft of torque.
Final Check
Make sure the retaining capscrews are properly
torqued.
1
3
H/27-3
H/27-1
H/26-2
H/27-2
H/26-8
H/26-1
4, 5
6
7
8
2