Transmission appearance may differ, procedure is the same.
29
External Parts
Line drawing
H/08-7
H/51-2
H/47-2
Shift Bar Housing
How to Install the Autoshift Assembly
Special Instructions
Make sure all labels are in the right place.
Note locations and positions of terminals and
connectors.
When connecting the in-line connectors, make sure the
wire locks into position. To check, pull gently on the
wires; if the wires resist they are locked.
Make sure air supply O-ring and gasket are in position.
Special Tools
Typical service mechanic tools needed
To Install
1.
Install the autoshifter air supply O-ring and
gasket.
2.
Postion the autoshifter assembly, align shift
finger with transmission and harness.
3.
Install the autoshifter with the four (4) hex head
bolts with washers.
Tighten to 20-30 Lb
f
·ft of
torque.
4.
Position the autoshift harness S4 lead end under
the washers in the HI range ball switch.
5.
Tighten the screws to 15-20 Lb
f
·in of torque.
6.
Position the autoshift harness S5 lead end under
the washers in the LO range ball switch.
7.
Tighten the screws to 15-20 Lb
f
·in of torque.
8.
Connect the 2 pin in-line connector for the input
shaft speed pick-up by inserting the contact wire
inside the insert cavity. Check that they are
locked.
9.
Connect the 2 pin in-line connector for the output
shaft speed pick-up by inserting the contact wire
inside the insert cavity. Check that they are
locked.
Final Check
Make sure the autoshift harness is connected exactly
like the line drawing shown at the top.
2
H/08-9
H/47-5
H/48-4
9
1
2
8
3
4, 5
6, 7
S 4
S 2
S 6
S 3
S 5
P 3
P 2
P 1
P 4
S 1
S 7
KEEP
WIRES
OUT
OF
THIS
AREA
TIE WRAP ALL WIRES - EXCEPT S2
S4
S6
S2
S1
S7
P2
P1
P4
P3
S5
S3