Transmission appearance may differ, procedure is the same.
27
External Parts
Shift Bar Housing
How to Install the Autoshift Harness
Special Instructions
Make sure all labels are in the right place.
Note locations and positions of terminals and
connectors.
When connecting the in-line connectors, make sure the
wire locks into position. To check, pull gently on the
wires; if the wires resist they are locked.
Special Tools
Typical service mechanic tools needed
To Install
1.
Install the three harness (3) ball switch terminals
(labeled S1, S2, and S3) mounted on the autoshift
housing end. Tighten to 14-20 Lb
f
·ft of torque.
2.
Install the four (4) brackets (with square end out)
and coils.
3.
Install the four (4) nuts on the solenoids. Tighten to
15-20 Lb
f
·in of torque.
4.
Install autoshifter gasket and O-ring.
5.
Install the autoshifter with four (4) hex head bolts
with washers. Tighten to 20-30 Lb
f
·ft of torque.
6.
Position the autoshift harness S4 lead ends under
the washers in the HI range ball switch.
7.
Tighten the screws to 15-20 Lb
f
·in of torque.
8.
Position the autoshift harness S5 lead ends under
the washers in the LO range ball switch.
9.
Tighten the screws to 15-20 Lb
f
·in of torque.
10.
Connect the 2 pin in-line connector for the input
shaft speed pick-up by inserting the contact wire
inside the insert cavity. Check that they are locked.
11.
Connect the 2 pin in-line connector for the output
shaft speed pick-up by inserting the contact wire
inside the insert cavity. Check that they are locked.
Final Check
Make sure the autoshift harness is connected exactly
like the line drawing shown for "How to Install the
Autoshifter Assembly".
H/09-3
H/09-1
H/47-5
H/48-4
H/09-2
H/47-6
H/51-2
H/47-2
1
3
2
4
5
11
10
6, 7
8, 9
