26
Transmission appearance may differ, procedure is the same.
H/46-9
H/47-2
H/47-6
H/09-2
1
2
3
H/47-1
H/51-2
H/09-1
H/09-3
8
7
6
4
3
Shift Bar Housing
How to Remove the Autoshift Harness
Special Instructions
Make sure all labels are in the right place.
Note locations and positions of terminals and
connectors.
Use the removal tool included on the harness to
disconnect the in-line connectors.
Special Tools
Typical service mechanic tools needed
To Remove
1.
Disconnect the 2 pin in-line connector from the
input shaft speed pick-up using the removal tool
located on the autoshifter harness. Slide the tool
along the wire into the insert cavity until it
engages the contact and resistance is felt. The
contact retaining clip will be in the unlocked
position.
2.
Pull the contact wire assembly out of the
connector.
3.
Repeat steps 1 and 2 to disconnect the output
shaft speed pick-up.
4.
On the shift bar housing, loosen the four (4) ball
switch screws on the range ball switches and
remove the autoshift harness terminals.
5.
Remove the four (4) hex head screws retaining
the autoshifter and remove the autoshifter, gasket
and O-ring.
6.
Remove the four (4) nuts from the four (4)
autoshift solenoids.
7.
Remove the brackets, retainers, and coils.
8.
Loosen the six (6) screws that hold the harness
on the three (3) autoshifter ball switches and
remove the harness terminals.
