Transmission appearance may differ, procedure is the same.
24
Input Shaft Assembly
How to Remove the Input Shaft Assembly
Special Instructions
The input shaft assembly is a non-serviceable
assembly, one exception is the seal rings which can be
purchased and replaced. Use fingers to install the new
seal rings.
Special Tools
Typical service tools are needed
Soft hammer
To Remove
1.
From the input shaft groove, remove the bearing
retaining snap ring.
2.
Use a soft hammer and drive the input shaft
toward the case rear as far as possible. Pull the
input shaft forward.
3.
Use pry bars or screwdrivers to complete
removal of the bearing.
4.
Push the input shaft through the drive gear and
out of the case.
5.
From inside the case, remove the drive gear and
spacer.
6.
Inspect the input shaft bushing, replace if
damaged.
7.
Remove the input shaft piston rings. They will be
replaced during the torque converter housing
installation.
8.
Inspect the tube inside the input shaft, replace if
damaged. Tighten to 65-79 Lb
f
·ft of torque.
H/33-8
H/33-9
H/34-2
H/34-4
H/33-7
H/35-1
H/34-1
H/34-3
1
2
3
4
5
6
7
8
8
