Eaton Tripp Lite SmartPro Series, Advanced User'S Manual

Page: 51 / 58

Tripp Lite by Eaton SmartPro Advanced User Guide 614-40195—Rev 01 39
Table 27. Alarm Fault Codes (Continued)
Fault Code Message Description
#607 BATTERY FAULT Battery need replacement OR is faulty
#004 UPS TEMP. FAULT UPS internal temperature is high, over fault point
#808 POWER OVERLOAD Overload counter time reach, transfer to Fault
mode
#805 OUTPUT SHORTED Short circuit on output
#107 INPUT BAD WIRING Site wiring fault that can come of Phase neutral
inversion on single phase UPS
#809 INDU OVERLOAD Inductive overload occurred, transfer to Fault
mode
#80A CAPA OVERLOAD Capacitive overload occurred, transfer to Fault
mode
#804 IMBALANCE LOAD Load is unbalance
#002 INTERNAL FAULT UPS Internal fault: Main relay abnormal
#002
SAFETY FAULT Safety relay is failure
#002 NTC ABNORMAL NTC abnormal
#105 AVR TOO HOT AVR is abnormal
#500
CHARGER FAULT Charger internal failure
#502 MAX CHARGER VOLT The charger voltage is >2.5VPC
#503 MIN CHARGER VOLT The charger voltage is <1.5VPC
77..33 S Siilleenncciinngg tthhee A Allaarrm m
Press the ESC (Escape) button on the front panel display to silence the alarm. Check the alarm condition and
perform the applicable action to resolve the condition. If the alarm status changes, the alarm beeps again,
overriding the previous alarm silencing.
77..44 S Seerrvviiccee aanndd S Suuppppoorrtt
If you have any question or problem with the UPS, call Eaton Tripp Lite Series or your local service
representative in your
country / region.
Please have the following information ready when you call for service:
• Model number
• Serial number
• Firmware version number
• Date of failure or problem
• Symptoms of failure or problem
• Customer return address and contact information
Troubleshooting