background image

1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1

2

Sonix Hmi-Tu Technical Manual

SONIX HMI-TU TECHNICAL MANUAL  

TM377 / A  June 2022  www.eaton.com

Disclaimer of warranties and limitation of liability 

The information, recommendations, descriptions and safety notations in this document are based on Eaton 
Corporation’s (“Eaton”) experience and judgment and may not cover all contingencies. If further information is 
required, an Eaton sales
office should be consulted. Sale of the product shown in this literature is subject to the terms and conditions outlined 
in appropriate Eaton selling policies or other contractual agreement between Eaton and the purchaser.

THERE ARE NO UNDERSTANDINGS, AGREEMENTS, WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING
WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR MERCHANTABILITY, OTHER THAN THOSE 
SPECIFICALLY SET OUT IN ANY EXISTING CONTRACT BETWEEN THE PARTIES. ANY SUCH CONTRACT STATES 
THE ENTIRE OBLIGATION OF EATON. THE CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR 
MODIFY ANY CONTRACT BETWEEN THE PARTIES.

In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability 
or other-wise for any special, indirect, incidental or consequential damage or loss whatsoever, including but not 
limited to damage or loss of use of equipment, plant or power system, cost of capital, loss of power, additional 
expenses in the use of existing power facilities, or claims against the purchaser or user by its customers resulting 
from the use of the information, recommendations and descriptions contained herein. The information contained in 
this manual is subject to
change without notice.

Glossary

Abbreviation

Meaning

PA/GA

Public Address and General Alarm

Sonix

Sonix PA/GA System

A&B

Duplicated PA/GA system architecture

N+1

Hot spare PA/GA system architecture

AB+

Sonix improved redundancy architecture

Hmi

Human interface

BGM

Background music

Tick-tone

Short burst of tone repeated every few seconds, used to check the output of connected loudspeakers

Sense Test

Periodic test carried by Sonix amplifi er to check integrity of 100 V line

100 V line

High voltage loudspeaker connection line at nominal 100 V ac

MCB

Miniature Circuit Breaker

RCBO

Residual current circuit breaker with overcurrent protection

Unit ID/Number

Unique identifi er assigned to each of Sonix module, used to identify it to the 2Mx and SAS.

Priority

Number assigned to a Sonix audio source to facilitate system usage confl ict resolution, 31 (highest) to 1 (lowest)

PTT

Push to talk

FAT

Factory Acceptance Test

SAT

Site Acceptance Test

Larson’s Effect

When a microphone is acoustically coupled to the loudspeaker and generates feedback

2Mx

Sonix 2Mx Central controller

Amp / 350-d

Sonix 350 W Power Amplifi er with 100 V line output

Eol1

Sonix Remote End of Line unit

Eol8

Sonix Amplifi er to 100 V line interface unit (8 channel)

SP AD

Sonix Intelligent loudspeaker monitoring unit

Hmi-Br

Sonix intrinsically safe barrier (ATEX/IECEx) for connecting Hmi-5 in explosive atmospheres

Hmi-Mute

Sonix 100V loudspeaker mute (Ex/SA)

Hmi-26

Sonix Human Interface access panel

Hmi-5

Sonix Small Human Interface access panel

Io

Sonix Input / Output unit

Ms12

Sonix 12-message digital message store

Pbx

Sonix Private branch exchange interface unit

Pm10

Sonix Power Management unit

Vw2

Sonix Beacon control and monitoring unit (2 channel)

SAS

Sonix Administration Software

Amp Bus

A 2Mx bus, used to communicate with and control Sonix Amplifi er units

HMI Bus

A 2Mx bus, used to communicate with and control Sonix Hmi units

I/O Bus

A 2Mx bus, used to communicate with and control Sonix input/output devices: IG, Io and Ms12

Beacon Bus

A 2Mx bus, used to communicate with and control Sonix Vw2 units

Power Bus

A 2Mx bus, used to communicate with and control Sonix Pm10 units

Global Bus

A 2Mx bus, used to communicate with SAS application

Sync

A 2Mx bus used to communicate with the second 2Mx unit when PA/GA system is confi gured as A&B, AB+ or N+1 

system

Summary of Contents for SONIX Hmi-Tu



















Reviews: