5 Take XSoft-CoDeSys-2 into operation
5.5 Change the device parameter of the gateway
34
SmartWire-DT Gateway EU5C-SWD-DP
01/13 MN120001Z-EN
www.eaton.eu
Figure 17:
Selection of the modules in XSoft-CoDeSys-2
If you cannot find a specific SWD module under the "Inputs/Outputs" tab, the
standard GSD file you are using may be obsolete. If this is the case, down-
load the latest version of the standard GSD file from the Eaton Support Cen-
ter
5.5 Change the device parameter of the gateway
The XSoft-CoDeSys-2 programming environment is also used to configure
parameters for the communications between the gateway and the field bus
master and the gateway and the SWD line, as well as the device parameters
for the SWD modules and the EU5C-SWD coordinator.
These are the meanings of the individual registers.
“Base parameters” register
Here you can define the I/O start addresses for the mapping of the SWD
modules onto the inputs and outputs of the controller map. As standard the
PLC programming tool creates complete connection to the I/Os up to now.
You can, however, change these values to other, unassigned areas.
“DP parameter” tab
The parameters that relate to communication with the field bus PROFIBUS-
DP are entered under these settings. These include, for example, the
address of the EU5C-SWD ("Module addresses" in XSoft-CoDeSys-2) field
bus module and the monitoring time for the field bus' cyclic data communica-
tions (watchdog control).
