Eaton S801T, Instructions For Installing

Page: 1 / 2

Instructions for Installing Lugs or Bus Interface Kits onto Soft Starter,
Models S801T/S811T, S801U/S811U, and S801V/S811V
The typical kit includes three lugs or bus interfaces with hardware for line or load side mounting on the S801T,
S801U,S801V, S811T, S811U or S811V frame. There are two screw lengths included with the typical kit. The 2 inch
screws are used for line side mounting. The 3 inch screws are used for load side mounting.
The EML40, universal lug kit, includes separate bus interface components and hardware. 1.75 inch screws are used
for line side mounting. 2.75 inch screws are used for load side mounting.
Effective 05/06
* Requires special lug cover. Check with EATON | Cutler-Hammer for availability.
Pub49000
Revision 01
TO AVOID SHOCK HAZARD,
DISCONNECT ALL POWER
BEFORE ANY FUNCTIONS
ARE PERFORMED ON THIS
EQUIPMENT.
AVERTISSEMENT
WARNING
Hazard of Burn or
Electrical Shock
Risque de Brulure ou de
Choc Electrique
POUR EVITER TOUT CHOC
ELECTRIQUE, COUPLER
L’ALIMENTA-TION DE CET
EQUIPEMENT AVANT D’Y
EFFECTUER DES TRAVAUX.
POWER WIRING
200mm
S801T/
S811T
S801U/
S811U
EML22
EML23
EML24
EML25
EML26
EML50
Frame
Size
Cat. No. Number of
Conductors
Wire Sizes
75°C only
Torque
Requirements
Number of
Kits Req’d
2
1
2
1
2
1.75” BUS
4-1/0 (21.2-53.5mm²)
4/0 - 500 MCM (107-240mm²)
4/0 - 500 MCM (107-150mm²)
2/0 - 300 MCM (70-150mm²)
2/0 - 300 MCM (70-150mm²)
N/A
28,3 N-m (250 LB-IN)
28,3 N-m (250 LB-IN)
28,3 N-m (250 LB-IN)
25,5 N-m (225 LB-IN)
25,5 N-m (225 LB-IN)
N/A
2
290mm
S801V/
S811V
EML28
EML30
EML32
EML33
EML40
EML51A
EML51B
2
4
6
4
4
2.00” BUS
3.00” BUS
4/0 - 500 MCM (107-240mm²)
4/0 - 500 MCM (107-240mm²)
4/0 - 500 MCM (107-240mm²)
2/0 - 300 MCM (70-150mm²)
4/0 - 500 MCM (107-240mm²)
N/A
N/A
28,3 N-m (250 LB-IN)
28,3 N-m (250 LB-IN)
28,3 N-m (250 LB-IN)
25,5 N-m (225 LB-IN)
34,0 N-m (300 LB-IN)
N/A
N/A
2
*