Eaton RSPF Series, Installation Instructions Manual, Page: 7 / 12

RSPF Series Surge Protective Device IL158004EN
Rev. 2 – December 2017 Page 5
Wiring Diagrams
Figure 8. Surge Ground Terminal connected to the
Ground Bus
Figure 9. Surge Ground Terminal connected to the
Neutral Bus
5 Operation
5.1 Power Up and System Checkout
Switch main panel power to ON. The green LED should
light to indicate the phase voltage is being monitored.
If the red LED lights, remove power and contact the
EatonCare Technical Resource Center at: 1-800-809-
2772, Option 4, sub-option 2, as the SPD may be
damaged.
If neither LED lights, remove power, check connections,
and test again. Verify that the proper voltage is present.
If the panel is energized properly and the LEDs still do
not light, contact EatonCare Technical Resource Center
at: 1-800-809-2772, Option 4, sub-option 2, as the SPD
may be damaged.
5.2 Alarm Silence Pushbutton
The RSPF SPD has an Alarm Silence Pushbutton
located below the red LED on the front to the SPD. The
alarm will sound when the red LED indicates that the
SPD has lost one or more phases of protection. To
silence the alarm after loss of protection press and hold
the the Alarm Silence Pushbutton for at least 1 second.
If the Alarm Silence Pushbutton does not silence the
alarm, contact EatonCare Technical Resource Center at:
1-800-809-2772, Option 4, sub-option 2, as the SPD
may be damaged.