221
Eaton RF-System
© 2015 Eaton Electrical Group
The configuration is now complete. Every selected actuator has been configured.
Configure group basic settings
This function serves the purpose of doing the settings for devices of the same type in one single
configuration window. It should be done before you make connections to other devices.
This function is available for the following devices:
- ) Switching actuator
- ) Dimming actuator
- ) Analogue actuator
- ) Heating actuator
- ) Binary input battery supplied
- ) Binary input 230V
- ) Motion detector
- ) Temperature input
- ) Room controller
- ) Room controller with humidity
- ) Analogue input
- ) Impulse input
- ) Energy measurement sensor
- ) BOS/COS interface
If there is a device in the selected group where a parameter is already locked (because there is a
Summary of Contents for RF System 2.42
