Eaton RF System 2.42, Manual

Page: 129 / 244

129 Eaton RF-System
© 2015 Eaton Electrical Group
You can set if channel A and/or channel B should be send cyclically and how fast a RF-command
is sent.
You can only scan the motion detector by pushing the activation key. The motion detector has to
be set to configuration mode and at least one channel should be activated.
After configuration is done the device can be mounted. Please note that all DIP-switches are set to
the desired states (mode operation,…).
Communication interface
The communications interface is used to enable the Eaton wireless system to communicate with
the PC, e.g. using display software or a different control system.
Actuators and sensors are allocated by means of datapoints as in the Home Manager. The
interface itself merely serves as a communication tool, whilst the process is controlled by means of
the software in the connected device.
Allocations from devices can be made in Comfort Mode, but also function in Basic Mode.
When connecting the communications interface to a PC for the first time using a USB, an
installation wizard opens to install the necessary USB driver (see below).
Firmware update
The communications interface firmware only functions via USB (not RS232).
Update sequence
Proceed as follows to load the latest firmware in the communications interface:
1. Connect the communications interface to a Windows PC using a USB (not via RS232). If
this is the first time that you are connecting to a PC, a driver installation window will open.
Simply click on "Continue" or OK. The driver which is installed is the standard windows HID
driver which is normally included in the operating system. The system may then need to be
restarted.