Eaton Rapid Link RAMO5, Manual

Page: 148 / 218

6 RASP5 Speed controller
6.7 Configure special settings
144
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
6.7.2 Motor cable monitoring
The monitoring is carried out via parameter P2-27.
Parameter P2-27 is set to the value 1 in the factory setting.
In position 0, the fault message of the thermistor and motor cable monitoring
is deactivated.
6.7.2.1 Sensor inputs
Sensor inputs I1 and I4 are laid out for rising-edge input signals (N/O, fail-
safe). Parameters P3-06 to P3-09 are set to 0 (= OFF) in the factory setting.
When using sensors (normally closed) that switch to zero, the parameters
must be set to 1 (= ON). The signal is then inverted.
Figure 96: Configuring the sensors inputs I1 and I2#
Four sensors are currently available:
I1 - I4 -> 1
I1 - I4 -> 0
Parameter Designation Description Unit Min Max DS
P3-06 DI1 Logic 0 = close
1 = open
Note:
Change only after POWER ON/OFF active
– 0 1 0
P3-07 DI2 Logic 0 = close
1 = open
Note:
Change only after POWER ON/OFF active
– 0 1 0
P3-08 DI3 Logic 0 = close
1 = open
Note:
Change only after POWER ON/OFF active
– 0 1 0
P3-09 DI4 Logic 0 = close
1 = open
Note:
Change only after POWER ON/OFF active
– 0 1 0
￫
Sensors I3 and I4 require a Y connector of type RA-XM12-Y.