3 Installation
3.6 Electrical Installation
DC1-S…20…, DC1-S…OE1 Variable Frequency Drives
05/21 MN040058EN
www.eaton.com
65
3.6.1 Connection to power section
The connection to the power section is normally made via the connection
terminals:
•
L1/L, L2/N, PE for the mains-side supply voltage.
•
U, V, PE for the connection to the motor
•
BR, DC+, PE for an external brake resistor
Figure 38: Connection in power section (schematic)
The number and the arrangement of the connection terminals used depend
on the variable frequency drive’s size and model.
NOTICE
The variable frequency drive must always be connected with
ground potential via a grounding conductor (PE).
L1/L L2/N L3
U
V
W
1
2
3
4
5 6 7 8 9 10 11
Summary of Contents for PowerXL
Page 4: ......