Eaton PowerXL, Installation And Parameter Manual

Page: 12 / 173

0 About this manual
0.5 Mains supply voltages
8
DC1-S…20…, DC1-S…OE1 Variable Frequency Drives 05/21 MN040058EN www.eaton.com
0.5 Mains supply voltages
The rated operating voltages stated in the following table are based on the
standard values for networks with a grounded star point.
In ring networks (as found in Europe) the rated operating voltage at the
transfer point of the power supply companies is the same as the value in the
consumer networks (e.g. 230 V).
In star networks (as found in North America), the rated operating voltage at
the transfer point of the utility companies is higher than in the consumer
network.
Example: 115 V
→ 110 V, 240 V → 230 V, 480 V → 460 V.
The DC1-S… variable frequency drive’s wide tolerance range takes into
account a permissible voltage drop of 10 % (i.e. U
LN
- 10 %).
The rated mains voltage operational data is always based on mains
frequencies of 50/60 Hz within a range of 48 to 62 Hz.
0.6 Units of measurement
Every physical dimension included in this manual uses international metric
system units, otherwise known as SI (Système International d’Unités) units.
For the purpose of the equipment’s UL certification, some of these
dimensions are accompanied by their equivalents in imperial units.
Table 1: Unit conversion examples
￫
The permissible power supply for the DC1-S… series can be
found in
￫ section 1.4.3, “Features”, page 15.
Designation US-American
designation US-American value SI value Conversion value
Length inch 1 in (’’) 25.4 mm 0.0394
Performance horsepower 1 HP = 1.014 PS 0.7457 kW 1.341
Torque pound-force inches 1 lbf in 0.113 Nm 8.851
temperature Fahrenheit 1 °F (T
F
) -17.222 °C (T
C
) T
F
= T
C
× 9/5 + 32
Rotational speed Revolutions per minute 1 rpm 1 min
-1
1
Weight pound 1 lb 0.4536 kg 2.205
Flow rate cubic feed per minute 1 cfm 1.698 m
3
/min 0.5889