2 Keypad
2.1 Operating unit elements
DB1 Variable Frequency Drives
09/17 MN040034EN
www.eaton.com
7
2 Keypad
The devices of the DB1 range can be configured using the optional keypads
DX-KEY-LED2 and DX-KEY -OLED.
They are connected to the device using an RJ45 patch cable.
2.1 Operating unit elements
The following diagram shows the elements of the external keypad
DX-KEY--LED2.
Figure 1: Operating unit view
Table 2: Keypad elements – Buttons
Display
Pushbuttons
Button
Command
Explanation
OK
• Opens and closes the parameter interface
• Saves parameter values
START
• Starting the variable frequency drive
1)
• Changing the operating direction
2)
STOP
• Stopping the variable frequency drive
1)
• Reset – Resetting after an error message
UP
• Accelerating
1)
• Increases the parameter value
DOWN
• Decelerating
1)
• Decreases the parameter value
Note:
1) Only if P-12 = 1 (one operating direction) or = 2 (two operating directions)
2) Only if P-12 = 2
