4 Operation
4.4 Using the operating unit
136
DA1 Variable Frequency Drives
08/18 MN04020005Z-EN
www.eaton.com
4.4.2 Setting parameters
Table 19: Modify parameters
4.4.3 Resetting Parameters (RESET)
Table 20: Resetting parameters (RESET)
Commands
Description
Press the
OK
button and hold it down for two seconds in order to access the parameter interface.
→
The display will show the parameter that was last used.
Use the
▲
and
▼
buttons to select a parameter.
Press the
OK
button.
The value of the selected parameter can be changed.
Use the
▲
and
▼
buttons to change the parameter's value.
Press the
OK
button to confirm the parameter value change.
As soon as the parameter is displayed, the value will have been saved.
Press the
OK
button and hold it down for two seconds in order to exit the parameter interface (display:
Stop
).
Switching between two parameter groups
The parameters are in sequential order. This means: Moving forward from the last parameter in a parameter
group will take you to the first parameter in the next parameter group and the other way around.
Note:
To access the extended parameter groups, you will need to enter the corresponding password in
parameter P1-14 (default passwords: level 2 = 101, level 3 = 201).
Press the
▲
and
STOP
buttons to jump to the first parameter in the next parameter group.
Press the
▼
and
STOP
buttons to jump to the first parameter in the previous parameter group.
Commands
Description
Reset to default settings
+
+
Press the
▲
and
▼
and STOP buttons and hold them down for two seconds.
→
All parameters will be restored to their default settings.
The display will show
P-dEF
.
Resetting after an error
Press the
STOP
button to reset after an error message.
The display will show
StoP
.
