Eaton PXGMS Card Quick Start Instructions 164000208—Rev 4
11
C
Chhaapptteerr 55 O
Obbttaaiinn aa D
DH
HC
CP
P--A
Assssiiggnneedd IIP
P A
Addddrreessss
To obtain the IP address through DHCP:
1.
Ensure the PXGMS card is still connected to the computer over the USB cable. Also ensure that the
network cable is connected from the PXGMS card Ethernet port to the network connection.
2.
If your Web browser already open to the default IP address, go to step 3. Otherwise, perform the
following:
a.
Open your Web browser.
b.
Enter:
https://169.254.0.101
for firmware 2.6.0 or later,
http://192.168.200.101
for earlier firmware
versions.
c.
Log on as administrator.
•
For firmware 2.6.5 and higher the username is “admin” and the default password is the card's
MAC address (case sensitive with no colons).
For example: Card's MAC address: 00:E0:D8:FF:C0:C4
–
Administrator name: admin
–
Password: 00E0D8FFC0C4
•
For firmware versions older than 2.6.5 the default username and password is “admin”.
The PXGMS card Web page displays.
NOTE
If the system is unresponsive and you cannot make any selections, the browser may be
running in compatibility mode. To disable compatibility mode, go to
Enable Browser Compatibility Mode
.
3.
Select
Network
from the Configuration menu. The
Network
page displays (see
Summary of Contents for Power Xpert PXGMS
Page 4: ...iv Eaton PXGMS Card Quick Start Instructions 164000208 Rev 4 Table of Contents ...
Page 6: ...2 Eaton PXGMS Card Quick Start Instructions 164000208 Rev 4 Installation Checklist ...
Page 22: ...18 Eaton PXGMS Card Quick Start Instructions 164000208 Rev 4 Assign an IP Address Manually ...
Page 28: ...1640002084 164000208 4 ...
