Eaton Power Xpert 9395P-600/600, Installation And Operation Manual, Page: 124 / 226

106 Eaton ® Power Xpert ® 9395P-600 (300V-600V) Installation and Operation Manual 164000710—Rev 07
Figure 47. Hot Sync CAN Bridge Card.
Plug-in Terminal
Block J3
NOTE Only one Hot Sync CAN Bridge Card can be installed in the UPS. Multiple CAN cards are
not supported and will cause system conflicts.
To install the card:
1. Verify the UPS system is turned off and all power sources are removed. See
Chapter 7 UPS Operating Instructions for shutdown instructions.
2. Unfasten the front door latch and swing the door open (see Figure 20 ).
3. Install the Hot Sync CAN Bridge Card into an open X-Slot communication bay on the front of the UPS. See
Figure 35 and Figure 41 for X-Slot communication bay locations.
To locate the appropriate terminals on the Hot Sync CAN Bridge Card, see Figure 48 and Table 35 .
Installing Options and Accessories