Eaton Power Xpert 9395P-1100/1100, Installation And Operation Manual, Page: 114 / 214

96 Eaton ® Power Xpert ® 9395P-1200 Installation and Operation Manual 164000500—Rev 11
55..11 IInnssttaalllliinngg aann O Oppttiioonnaall P Poow weerrw waarree H Hoott S Syynncc C CA AN N B Brriiddggee C Caarrdd
As an option, a Powerware Hot Sync Controller Area Network (CAN) Bridge Card, shown in Figure 48 , can be
installed to provide connectivity for operational mode control of a parallel system. In addition, this card can be
used to connect optional system monitoring devices, such as a Remote Monitor Panel II, a Relay Interface
Module II, or a Supervisory Contact Module II to the UPS.
Figure 48. Powerware Hot Sync CAN Bridge Card.
Plug-in Terminal
Block J3
NOTE Only one Powerware Hot Sync CAN Bridge Card can be installed in the UPS. Multiple
CAN cards are not supported and will cause system conflicts.
To install the card:
1. Verify the UPS system is turned off and all power sources are removed. See
Chapter 7 UPS Operating Instructions for shutdown instructions.
2. Unfasten the front door latch and swing the door open (see Figure 17 ).
3. Install the Powerware Hot Sync CAN Bridge Card into an open X-Slot communication bay on the front of
the UPS. See
Figure 37 and Figure 43 for X-Slot communication bay locations.
To locate the appropriate terminals on the Powerware Hot Sync CAN Bridge Card, see Figure 49 and
Table 29 .
Installing Options and Accessories