GETTING STARTED
EATON
Power Xpert
®
Gateway Series 1000 Card User’s Guide
S
164201670 Rev 1
16
Network Configuration
If you know the card’s IP address, you can configure the network
settings from the card’s Web page:
1.
Open a Web browser, type the IP address of the card, and select
Go
.
2.
The login prompt appears. The user name and default password is
user
for read-only information and
admin
for configuration
(read/write) options. Log in as
admin
.
The PXGX Series 1000 Card Web page opens (see Figure 18).
Enter the Card’s IP Address
Figure 18. PXGX Series 1000 Card Web Page
3.
Select the
Network
link from the menu bar.
The Network Configuration Settings page appears. The page shows
the current network status for each port on the card (green
indicates the network is connected; red indicates the network is
disconnected).
4.
You can enable or disable the DHCP control by activating or
deactivating the check box. The default is
DHCP enabled
.
Summary of Contents for POW-R-COMMAND 1000
