Eaton PDI WaveStar TFA Static Transfer Switch Installation and Operation Manual P-164001113—Rev 01
75
C
Chhaapptteerr 1100 S
Syysstteem
m S
Seettuupp:: A
Addm
miinniissttrraattiioonn
This chapter describes administrative setup.
1100..11
A
Addm
miinniissttrraattiivvee A
Acccceessss LLeevveell
Anyone can view the different display screens, but a login is required to use controls or make changes to
parameters.
The STS has four access levels:
1.
PDI:
This level has authorization for all actions except clearing the
Event Log
. Eaton access is required to
use the
Configuration
screen.
2.
Service:
This access level is for Eaton authorized service representatives. This level has authorization for
all actions except clearing the
Event Log
.
3.
Administrator:
This access level has authorization for all actions and screens except Configuration
Screen, which is not available to users.
NOTE:
The Administrator is the only user who can clear the
Event
Log
!
4.
Operator:
An operator can only change the
Preferred Source
.
1100..22
IInniittiiaall A
Addm
miinniissttrraattoorr A
Acccceessss
STS security is based on the identification of each user by a PIN with an associated password. The PIN
identifies the user and the password allows access. This scheme also provides login history and accurate
forensics if there is problem with the STS.
To initially set up STS users, Eaton provides a temporary Administrator PIN and password. The administrator
should:
1.
Log in on the
Home
screen in the
Operator
panel.
2.
Navigate to the
Users
screen
3.
Change the administrator PIN and password and then keep them secure.
4.
Set up each user’s security information as described in the following sections.
After initial startup, commissioning, testing, or restart, the administrator should clear any alarms that occurred.
1100..33
U
Usseerrss S
Sccrreeeenn
•
Touch the
User
button at the bottom of a display screen to display the
Users
Screen (see
•
The
Users
screen:
–
Allows the Administrator set up new users and their level of access to the s witch.
–
Displays the names of registered users and unassigned slots.
•
Scroll through the User list using the scroll bar on the right side of the screen to highlight a user name or
number.
•
Set up or modify a user’s profile using the
Name
,
PIN
,
Password,
and
Class
buttons. Each user must be
assigned a Password and PIN.
•
The Administrator sets a user’s access Class by touching the
Class
button and entering the first letter of
the Class:
–
A: Administrator
–
S: Service
Summary of Contents for PDI WaveStar TFA STS 250-600A
Page 4: ......
Page 150: ...P 16400111301 P 164001113 01 ...
