38
Eaton PDI WaveStar TFA Static Transfer Switch Installation and Operation Manual P-164001113—Rev 01
Figure 22. Installing on Floor Stand with Side Brackets
M
Moouunnttiinngg w
wiitthh ssiiddee aanndd rreeaarr bbrraacckkeettss
In constrained spaces, the Installer may not be able to reach the rear mounting holes of the side floor stand
brackets. In that case, follow these steps:
1.
Determine the position of the TFA floor stand and TFA STS precisely, including clearances.
2.
Create floor cutouts for the floor stand.
3.
Using corner all-thread screws, adjust height of floor stand to match raised floor.
4.
Attach rear brackets to floor stand. See recommended hardware stack in
5.
Place floor stand in floor cutout location. Attach the floor stand corner mounting plates to the floor using (4)
screws or bolts for each corner plate. Installer chooses attachment hardware.
6.
Place the TFA STS so that STS side bracket holes are over the floor stand holes. Use a forklift or palette
jack rated for the unit’s weight. Insert forks from the front of the unit. Do not tilt the unit more than 10°.
7.
Using the front bracket holes, attach the left and right floor brackets to the floor stand. See recommended
hardware stack in
.
8.
The unit has pre-drilled holes for attaching the rear brackets. Place the TFA STS so that the holes are over
the rear brackets.
Summary of Contents for PDI WaveStar TFA STS 250-600A
Page 4: ......
Page 150: ...P 16400111301 P 164001113 01 ...
