Eaton PDI Revit Model
P-164001110—Rev 01
15
3.
Align the middle axis of the Standard Rail with the middle axis of the Starter Rail and constrain the end of
the Starter Rail with the end of the Standard Rail. (If multiple Standard Rails are used, constrain the end of
one with the end of the other.)
Figure 15. Middle Axis Alignment — Standard Rail to Starter Rail
4.
Be sure to align the rails on the same plane in the South elevation view. This can be done by placing a
dimensional constraint from the bottom reference line to the rails (dimensions under each rail must be the
same.)
Figure 16. Multiple Standard Rails— Dimensional Constraint
0’
- 5 3/8”
0’
- 5 3/8”
0’
- 5 3/8”
0’
- 3 1/8”
0’ - 0”
5.
The length of the Standard Rail can be adjusted in Revit to fit your needs (adapt the steps in
, 2a-2d for Standard Rail.)
44..44
EEnndd C
Caapp
Every bus run must be terminated by an End Cap.
1.
Import the End Cap model.
2.
Align the middle axis of the End Cap with the middle axis of the Standard Rail and constrain the end of the
Standard Rail with the end of the End Cap (use Starter Rail in a 1–rail system.)
Figure 17. Middle Axis Alignment — End Cap to Standard Rail
