www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card
– User Manual
34003991XT_EN/JC
Page
39/143
4.2.4 UPS control
UPS configuration may prevent the shutdown and restart commands from being properly run. Read the UPS user
manual for more information.
This page enables triggering of
startup and shutdown sequences
for the UPS main output and controlled outlets.
•
The status of each output is displayed by a symbol associated with the Off label (red symbol) or On
(green symbol).
•
The shutdown sequences take into account the time required for the registered servers to shut down
without losing data
(
see shutdown parameters
).
•
The main outlet has priority over the controlled outlets. Shutdown of the main outlet causes the
controlled outlets to shut down. Controlled outlets can only be started if the master outlet is on.
The system proposes six different commands, and a command is only actually started after clicking on
Execute
:
•
Safe power down
: A sequence to switch off output power is launched immediately. The systems
supplied are shut down correctly while the shutdown sequence is running, then the output is cut.
•
Safe power down & reboot
: A sequence to switch off then restore output power is launched
immediately. The powered systems are shut down correctly during the shutdown sequence, then the
output is switched off.
•
Finally, the restart sequence is launched at the end of the time delay specified in the "Toggle duration"
parameter. The output status is updated.
