Eaton Network-M3, User Manual, Page: 269 / 294

CLI
Information – 269
•
•
Trap oid :
.1.3.6.1.4.1.534.10.2.10.x
Trap description
.1.3.6.1.4.1.534.10.2.10. 22 Remote temperature normal
.1.3.6.1.4.1.534.10.2.10. 23 Remote humidity low
.1.3.6.1.4.1.534.10.2.10. 24 Remote humidity high
.1.3.6.1.4.1.534.10.2.10. 25 Remote humidity normal
.1.3.6.1.4.1.534.10.2.10. 26 Contact 1 active
.1.3.6.1.4.1.534.10.2.10. 27 Contact 1 inactive
.1.3.6.1.4.1.534.10.2.10. 28 Contact 2 active
.1.3.6.1.4.1.534.10.2.10. 29 Contact 2 inactive
7.6.3 Sensor Mib
7.6.3.1 Sensor Mib traps
This information is for reference only.
Trap oid :
.1.3.6.1.4.1.534.6.8.1.x.x.x Trap description
.1.3.6.1.4.1.534.6.8.1.1.0.1 Sent whenever the sensor count changes after a discovery or removing from the UI.
.1.3.6.1.4.1.534.6.8.1.1.0.2 Sent whenever one status of each sensor connected changes.
.1.3.6.1.4.1.534.6.8.1.2.0.1 Sent whenever one status of each temperature changes.
.1.3.6.1.4.1.534.6.8.1.3.0.1 Sent whenever one status of each humidity changes.
.1.3.6.1.4.1.534.6.8.1.4.0.1 Sent whenever one status of each digital input alarm changes.
7.7 CLI
CLI can be accessed through:
SSH
Serial terminal emulation (refer to section
Servicing the Network Management Module>>>Installing the Network
Module>>>Accessing the card through serial terminal emulation ).
It is intended mainly for automated configuration of the network and time settings of the network card. It can also be used for
troubleshooting and remote reboot/reset of the network interface in case the web user interface is not accessible.
Warning: Changing network parameters may cause the card to become unavailable remotely. If this happens it can only be
reconfigured locally through USB.
7.7.1 Commands available
You can see this list anytime by typing in the CLI:
?