Eaton Network-M3, User Manual

Page: 261 / 294

List of event codes
Information – 261
7.5.4 ATS alarm log codes
7.5.4.1 Critical
Code Severity Active message Non-active message Advice
F03 Critical Internal failure End of internal failure -
F08 Critical Internal failure End of internal failure -
F0B Critical Internal failure End of internal failure -
F0D Critical In short circuit Not in short circuit -
F10 Critical Load not powered Load powered with no continuity -
F11 Critical Internal failure End of internal failure -
F13 Critical Temperature out of range Temperature in range -
F1B Critical Off On preferred source -
7.5.4.2 Warning
Code Severity Active message Non-active message Advice
F00 Warning Unsynchronized sources Synchronized sources -
F01 Warning Frequency out of range Frequency in range -
F02 Warning Out of range In range -
F04 Warning Voltage in derated range Voltage in normal range -
F06 Warning Frequency out of range Frequency in range -
F07 Warning Not in range In range -
F09 Warning Voltage in derated range Voltage in normal range -
F0C Warning In overload Not in overload -
F0F Warning Internal configuration failure Internal configuration OK -
F12 Warning Overload Fault No overload fault -
F15 Warning Input waveform is not OK Input waveform is OK -
To retrieve Alarm logs, navigate to Contextual help>>>Alarms section and press the Download alarms button.
Below codes are the one to be used to add "Exceptions on events notification" on email sending configurations.
Some zeros maybe added in front of the code when displayed in emails or logs.