Eaton Network-M3, User Manual

Page: 151 / 294

Device details
Contextual help of the web interface – 151
•
•
•
•
•
•
•
•
•
3.8.3 Settings - ATS
Audible alarm - To enable / disable the sound emitted by the UPS when an alarm is triggered ( Battery replacement alarm for
instance or UPS technical fault )
Prefered source – To set the priority on Source 1 or Source 2 (Source 1 by default).
Sensitivity – To set the sensitivity mode for input mains detection
Normal sensitivity by default
Low sensitivity for compatibility with distorted waveform
High sensitivity when the load demands higher power stability
LIA UPS Input when the power source of the ATS is a Line Interactive UPS
Transfer mode – To set the transfer mode between sources (Standard by default with no additional break even if sources are
no synchronized, Gap with additional break during transfer if sources are not synchronized).
Nominal voltage – To set voltage thresholds.
3.8.3.1 Specifics
3.8.3.2 Access rights per profiles
Administrator Operator Viewer
ATS
3.8.3.2.1 For other access rights
This section is only for the ATS device and contains all its settings.
Device unique attributes
Some options proposed may not apply to your device. Please refer to the device User Manual Guide.
For other access rights, see the Information>>>Access rights per profiles section.