IMPORTANT NOTES
1. This product should be installed, commissioned and maintained by or under the supervision of a competent electrician
in accordance with current electrical engineering Codes of Practice, Regulations for the Electrical equipment of
Buildings (BS7671), CDM2007 - Construction (Design and Management) Regulations 2007, HSG150 - Health and
Safety in Construction, Statutory requirements and any Specific instruction issued by the Company.
2. After completing the installation and testing of this product it is essential that this leaflet is drawn to the attention of
the person responsible for its future operation and maintenance, and is at all times available for ready reference.
3. These notes assume throughout that the product is disconnected from the supply. It is essential that this is done
before any work is carried out.
4. These Panelboards are only designed for use with Eaton MCCBs. Failure to comply will result in invalid warranty and certification.
5. Operation of the incoming and outgoing devices should only be carried out by an instructed or skilled person.
Memshield 3 630/800A Panelboard/Pan Assemblies
EPBN2863, EPBN21263, EPBN21863, EPBN3880, EPBN31240
EPBPN2863, EPBPN21263, EPBPN21863, EPBPN3880, EPBPN31240
Instruction leaflet LT1210 (
12
/1
9
)
630A MCCB INCOMER FITTING
EPBKN2633
EPBKN2634
NOTE: When Top Fed, MCCB terminations must be reversed
800A MCCB INCOMER FITTING
EPBKN3803
EPBKN3804
Position
on Cover
14Nm
31Nm
31
Nm
46Nm
Position
on Cover
14Nm
31Nm
630A DIRECT CABLE
INCOMER FITTING EPBKN263L
(FOR 630A PANELBOARDS ONLY)
MCCB INCOMING COVER
KNOCKOUT REMOVAL
DO NOT REMOVE FOR DIRECT
CABLE INCOMER
14Nm
Remove for 4 Pole
Bottom Feed Incomer
Remove for 3 Pole
Top and Bottom
Feed Incomer
Remove for
4 Pole Top
Feed Incomer
The use to which this product is put and its place of installation is outside our
control.
Particular care should therefore be taken to follow the instructions given here and to
ensure their continued availability in conjunction with the use of the product.
No responsibility can be accepted by us if these instructions are disregarded.
Further
copies of these instructions and information concerning the installation
and proper use
of this product can be obtained by contacting the:
Technical Services Department
Eaton Electric Limited,
Middleton
,
Manchester
,
M24 1GQ
.
Tel: +44(0)8700 545 333,
email: [email protected]
www.eaton.com/recycling
LH OUTGOING CIRCUITS RH OUTGOING CIRCUITS
FED FROM:
INCOMING CABLE SIZE:
INSTALLATION DATE:
CONTRACTOR:
Warning -
Intellectual Property Rights
Eaton wishes to make it clear that it
owns intellectual property rights in the
product which it manufactures (whether
or not listed in this leaflet) and that it will
take legal action against any party
found to be manufacturing, using, or
selling any article which infringes the
company’s intellectual property. All
marks in this document identified with
an R symbol or a TM symbol adjacent
to the mark are trademarks of Eaton.
© 20
1
9
Eaton Electric Limited,
All rights reserved.
BOTTOM FEED
L1
LABEL FITTING
Ensure all way labels are fitted in the correct places
Busbar
Way
Label
TOP FEED
Phase Label
Earth
Labels
Earth
Labels
L1
Cover Way
Labels
Main Switch
Label
Cover Way
Labels
Main Switch
Label
L1
