Fixing Centres
Suspension Ceiling Fixing
Fix ceiling boss
mounting surface
using suitable
wood screw
Feed 1-5m long wire
into body as shown
- screw body into
ceiling boss
a) Follow procedures ‘a’ to ‘c’ as per ‘Surface
Bracket Installation’.
b) Fix suspension wire to surface (see ‘Suspension
Ceiling Fixing’).
c) locate the suspension wire thread through
the central surface bracket hole, and secure
with supplied M4 nut supplied. Offer the
Leat up to the surface brackets and fix
Suspension Wire Installation
3
c)
Disconnect the connecting block
from the geartray to the housing.
Then fully remove the geartray.
a)
Remove diffuser using the
suction cup (supplied) positioned
at the centre of the diffuser.
(Stand alone only)
b)
Using a screwdriver, gently
disengage the geartray using
the slotted tabs
Fixing Centres
1.0m
1.5m
2.0m
700mm
central fixing
3.0m
1200mm
1700mm
d)
Once spring clips are secure, fix housing into the spring clips.
Ensure the spring clips are located above the 21mm diameter
holes in the back of the housing, for future removal.
(see table for hole locations).
e)
Wire (as shown in section 4)
supply cable into luminaire,
re-connect the connecting
block and fix geartray and
diffuser back into place
2
Surface Bracket Installation
IMPORTANT DO NOT REMOVE ENDCAPS
December 2019
Leat
Instruction Manual - K1121V10
