Eaton IQ 150S, User & Installation Manual

Page: 54 / 234

IM02601006E www.eaton.com 5-4
IQ 150S/250S 5: Communication
5.1.3: Ethernet Connection
In order to use the IQ 150S/250S submeter’s Ethernet capability, the Ethernet Module must be
installed in your meter, and the JP2 must be set to positions 2-3. You can use either wired
Ethernet, or WiFi.
For wired Ethernet, use Standard RJ45 10/100BaseT cable to connect to the IQ 150S/250S
submeter. The RJ45 line is inserted into the RJ45 port of the meter.
For WiFi connections, make sure you have the correct antenna attached to the meter.
Refer to Chapter 6 for instructions on how to set up the Network Module.
** See the JP2 figure and instructions on page 5-2.
Electronic Circuits
Ia Ia Ib Ib Ic Ic
(+) (-) (+) (-) (+) (-)
Z K Y + - SH
Va Vb Vc Vn L1 L2 PE
RS-485
Wireless Ethernet Connection
To Other
Devices
JP2: Must be in
position 2-3 for
Ethernet (RJ45 or WiFi)
Ethernet Module
**