Eaton IQ 150S, User & Installation Manual

Page: 127 / 234

IM02601006E www.eaton.com 6-11
IQ 150S/250S 6: Ethernet Configuration
Swap 4x/0H to get 3x/1x (N) ? N
Local slave address for GPIO (0 to disable, or 1..255) (0) ? 0
WLAN Settings Detail (6) (The settings shown are recommended by Eaton for use with IQ
150S/250S submeter.)
Topology: 0=Infrastructure, 1=Ad-Hoc <1> ? 0
Network name <SSID> <LTRX_IBSS> ? Eaton_IQ150S_250S
Security suite: 0=none, 1=WEP, 2=WPA, 3=WPA2/802.11i <0> ? 0
TX Data rate: 0=fixed, 1=auto fallback <1> ? 1
TX Data rate: 0=1, 1=2, 2=5.5, 3=11, 4=18, 5=24, 6=36, 7=54 Mbps <3> ? 7
Enable power management <N> ? Y
IMPORTANT NOTES:
• The settings for the Wireless Access Point should be IDENTICAL to the settings for LWAN,
shown above. For programming, see the User's Manual for the Wireless Access Point in use.
• See Section 6.3.4.1 for information on using an Encryption key.
Exiting the screen
CAUTION! DO NOT PRESS 'D.'
Press 'S' to Save the settings you've entered.
6.3.4.1: Encryption Key
Eaton recommends that you use 128-bit encryption when setting up your Ethernet configuration.
In the WLAN Settings (6), set Security WEP (1), Authentication shared (1), WEP128 (1) and
Change Key (Y).
When Change Key (Y) is entered, you are required to enter an Encryption Key. You can manually
enter 26 hexadecimal characters (required for 128-bit encryption) or you can use a WEP Key pro-
vider online (example: www.powerdog.com/wepkey.cgi). WEP Key providers should note on their
website that their encryption algorithm is for the Wired Equivalent Privacy portion of
IEEE 802.11b/g.